June 10 2024 09:47 AM

Sent in by David Salvador from California.

We built a feed pusher that can fit onto any tractor or loader on our dairy. We found most commercial feed pushers are made for specific makes and models of tractors and are not cheap.

We cut the flaps off a steel I-beam that we had left over from building a barn. We then took a used tractor tire, cut it to fit as our rubber strip, and bolted it into holes that we drilled into the I-beam. After that, we took square tubed pipe and measured it to fit any tractor or loader on our property and welded it all together.

- David Salvador, California